Tru Tack Asphalt Joint Sealer
Tru Tack Asphalt Joint Sealer
APPLICATIONS
Tru Tack is a bitumen cold joint sealer and tack coat spray that is applied onto vertical edges and the surface base before the application of asphalt/ asphalt repair materials. It will increase the bond of the material to the substrate and waterproof the area. This will significantly enhance the reinstatement’s performance by preventing the ingress of water and freeze/thaw effect.
TECHNICAL
Tru Tack is supplied in 750ml cans with the bitumen being discharged by inverting the container and pressing the spray button.
PREPARATION
Remove as much standing water and loose particles as possible prior to product application. The sealer can be applied to damp or dry surfaces.
APPLICATION
Hold the can tightly and shake vigorously before use. Invert the can and press the spray button. Cover the area to be sealed with long strokes from a distance of 175mm to 250mm working from the top downwards. Ensure that the entire surface is covered.
CLEANING
Point nozzle upward immediately after use and spray for a few seconds to clear it, taking care not to spray into wind. Failure to clean the nozzle after use could result in the aerosol becoming blocked rendering the product unusable.
APPLICATIONS
Tru Tack is a bitumen cold joint sealer and tack coat spray that is applied onto vertical edges and the surface base before the application of asphalt/ asphalt repair materials. It will increase the bond of the material to the substrate and waterproof the area. This will significantly enhance the reinstatement’s performance by preventing the ingress of water and freeze/thaw effect.
TECHNICAL
Tru Tack is supplied in 750ml cans with the bitumen being discharged by inverting the container and pressing the spray button.
PREPARATION
Remove as much standing water and loose particles as possible prior to product application. The sealer can be applied to damp or dry surfaces.
APPLICATION
Hold the can tightly and shake vigorously before use. Invert the can and press the spray button. Cover the area to be sealed with long strokes from a distance of 175mm to 250mm working from the top downwards. Ensure that the entire surface is covered.
CLEANING
Point nozzle upward immediately after use and spray for a few seconds to clear it, taking care not to spray into wind. Failure to clean the nozzle after use could result in the aerosol becoming blocked rendering the product unusable.